| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
03-16-2012, 02:16 PM
| #1 |
| I joined the Band! Join Date: Feb 2012 Location: bay area
Posts: 66
|  Gear box specs and measurements for the Super Clod
I'm looking to make a hybrid axle based on the super clod gears. I'm looking to graft them into an Integy IROCK 1/8 gear housing on an Exceed Maxstone 1/8 axle. So far I have functioning axles with stock plastic gears in the alloy Integy IROCK gear box mated to Exceed Maxstone axle tubes and axle shafts With Integy IROCK alloy knuckles and inner C's. I have been on the hunt for alloy gears to add longevity to the axles. So far in my research I have found that the IROCK alloy gears have been on backorder and the Super Clod has available alloy gears. In a online comparison both axles share gears of the same tooth count (15t on 50t) but I am unsure if the pitch is the same. My current setup has 32 pitch gears and If the Super clod is also 32 pitch I can turn them on a lathe and adapt them. Can anyone confirm the specs on the super clod gears? Thanks in advance!  -707 |
|  |
| Sponsored Links | |
| | |
|
03-26-2012, 04:34 PM
| #2 |
| I joined the Band! Join Date: Feb 2012 Location: bay area
Posts: 66
| Re: Gear box specs and measurements for the Super Clod
Anybody? I'm sure somebody has a clod axle apart that knows what the pitch and tooth counts are.
|
|
| |
|
03-27-2012, 01:12 AM
| #3 |
| Quarry Creeper Join Date: Dec 2009 Location: in front of you...
Posts: 248
| Re: Gear box specs and measurements for the Super Clod
32p...
|
|
| |
|
03-27-2012, 10:37 AM
| #4 |
| I joined the Band! Join Date: Feb 2012 Location: bay area
Posts: 66
| Re: Gear box specs and measurements for the Super Clod
Thanks man!  |
|
| |
|
03-29-2012, 09:27 PM
| #5 |
| Quarry Creeper Join Date: May 2004 Location: SW of Chicago
Posts: 212
| Re: Gear box specs and measurements for the Super Clod
Only the final gear that the motor drives is 32P. It is a 50T The rest of the gears are metric Mod1. Off the 50T is a 15T that drives a 44T with another 15T that feeds the dif/spool of 40T. 50/P x 44/15 x 40/15 |
|
| |
|
Gear box specs and measurements for the Super Clod - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bad Mesh on bevel gear and diff gear out of the box? | Elliott000 | Axial SCX-10 | 3 | 08-19-2011 06:37 PM |
| Box Measurements | canadianlimited | Electronics | 4 | 12-29-2009 08:20 AM |
| metal gear for txt-1 centre gear box??? | satin's truck | Tamiya Txt-1 and Juggernaut | 12 | 11-12-2006 11:59 AM |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
