Parallel wiring/EVX2/Single 7.2v stickpack? as the title says... i have the EVX2 with the one battery connector bridged to allow me to run a single 7.2v stickpack on my clod. as it stands it is wired as it should be with one set to the front and another to the rear from the ESC to the motors. or can it be done? would it destroy the EVX2? thanks "thumbsup" |
Re: Parallel wiring/EVX2/Single 7.2v stickpack? Why not run the motors as stock wired? |
Re: Parallel wiring/EVX2/Single 7.2v stickpack? if i am correct....the stock setup would be series meaning longer runtimes. i want more juicey-juice! "thumbsup" but can it be done or am i goin about this wrong? another question: im in the middle of a DIG setup using the Traxxas micro servo which is installed on a platform above my skidplate. I have the stock Clodbuster "Power switch" that used to be installed on the side of the plastic chassis. Can this swithc handle the amperage from a motor in the 50-60+ turn range? http://a5.sphotos.ak.fbcdn.net/hphot...48353548_n.jpg |
All times are GMT -6. The time now is 02:06 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com