| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
06-01-2012, 01:51 PM
| #1 |
| Rock Stacker Join Date: Apr 2005 Location: RC SYNDICATE
Posts: 90
|  Parallel wiring/EVX2/Single 7.2v stickpack?
as the title says... i have the EVX2 with the one battery connector bridged to allow me to run a single 7.2v stickpack on my clod. as it stands it is wired as it should be with one set to the front and another to the rear from the ESC to the motors. or can it be done? would it destroy the EVX2? thanks  |
|  |
| Sponsored Links | |
| | |
|
06-01-2012, 05:56 PM
| #2 |
| RCC Addict Join Date: Aug 2008 Location: Paulina
Posts: 1,213
| Re: Parallel wiring/EVX2/Single 7.2v stickpack?
Why not run the motors as stock wired?
|
|
| |
|
06-02-2012, 01:05 AM
| #3 |
| Rock Stacker Join Date: Apr 2005 Location: RC SYNDICATE
Posts: 90
| Re: Parallel wiring/EVX2/Single 7.2v stickpack?
if i am correct....the stock setup would be series meaning longer runtimes. i want more juicey-juice! but can it be done or am i goin about this wrong? another question: im in the middle of a DIG setup using the Traxxas micro servo which is installed on a platform above my skidplate. I have the stock Clodbuster "Power switch" that used to be installed on the side of the plastic chassis. Can this swithc handle the amperage from a motor in the 50-60+ turn range?  Last edited by Torredo; 06-02-2012 at 02:05 AM. |
|
| |
|
Parallel wiring/EVX2/Single 7.2v stickpack? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EVX2 wiring?? | SwampDawg | Tamiya Clod Buster | 11 | 11-08-2010 07:37 AM |
| Battery parallel wiring question | pdm | Electronics | 1 | 01-09-2009 01:30 PM |
| wiring lipo's in parallel? | fantomas | Electronics | 1 | 01-11-2007 07:29 PM |
| parallel wiring Question | Over-Rev | Tamiya Clod Buster | 3 | 11-16-2005 03:04 PM |
| Parallel Wiring | Crawly | Electronics | 13 | 07-14-2005 12:22 AM |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
