Bearing Oil I just wanted to check in to see what OIL everyone is using to lube their CR-01 bearings before I start my build? |
None at first. But I have gone back through the truck with some Trinity oil. |
I have Trinity oil as well. I've only cleaned and re-oiled the bearings once since I've had this rig and that was about 2 weeks ago. And I only did the bearings in the ends of the axles and where the drive shafts enter. They probably didn't even need it, when i removed them they all spun perfectly, even after all those water crossings:) |
i usualy soak my bearings in zoom spout turbine oil when i rebuild my stuff. |
Thanx for the tips! I'll juice them up before install! |
wat kind of grease would be good for stuffing in the axles and tranny gears to prevent water from entering? i am running out of the grease that came with the kit and wantd to get sum more, thanks. |
Water will get in the tranny regardless. That big opening in back where the pinion is will let it in unless you can block it off somehow. |
All times are GMT -6. The time now is 06:53 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com