Problems with punishers I installed the punishers on my cr 01. They worked great for a day of two and now the rear one going into the axle just slips. Anyways I wanted to remove them and go back to the stocks to take out for a ride and now it wont come off. I tried wd 40, bearing oil and even pliers to take it off.... It wont budge. It spins freely but I cant get it off. Any help will be great. THX guys"thumbsup" |
Are ya sure its the shaft and not in the diff? If you used locktie it will be hard to get loose.I have some spruce pliers and I just go between the drive shaft and diff housing and clamp down. "thumbsup" http://www.amainhobbies.com/product_...Spruce-Cutters |
I cant remove the the punisher driveshaft half going to the axle. |
All times are GMT -6. The time now is 01:03 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com