12-18-2016, 07:56 PM | #1 |
Newbie Join Date: Dec 2016 Location: Under a Bridge
Posts: 2
| Axle assembly question
I'm assembling a cr01 and have a question about the axle assembly. The manual say they are tilted at 15deg front and 25 deg rear. How can I determine if I stalled them correctly on the chassis? Thanks in advance. |
Sponsored Links | |
12-20-2016, 06:30 AM | #2 |
I wanna be Dave Join Date: Sep 2011 Location: Douglassville, PA
Posts: 4,225
| Re: Axle assembly question
Build the links and install them in the holes shown in the manual and it should come right...I don't recall any issues when building my 3 kits - just pay careful attention to what goes where. It can get hairy with all those links, holes, and spacers. If you are unsure, post a pic from the side - a picture says 1000 words. |
12-20-2016, 12:23 PM | #3 |
Newbie Join Date: Dec 2016 Location: Under a Bridge
Posts: 2
| Re: Axle assembly question
The springs in the front (on the left) seem like they are sort of "bent" and leaning. What do you think? |
12-26-2016, 04:56 AM | #4 |
Newbie Join Date: Oct 2015 Location: Lancaster
Posts: 12
| Re: Axle assembly question
There are "15" and "25" markings on the lower part of the hub mouldings which line up with marking on the axle case. Sent from my iPad using Tapatalk |
12-26-2016, 07:44 AM | #5 |
I wanna be Dave Join Date: Sep 2011 Location: Douglassville, PA
Posts: 4,225
| Re: Axle assembly question
Everything seems spot on to the manual. I know sometimes the springs can get set improperly in the retainers. Try loosening up the retainers and rotating the spring until it seats in a better position.
|
Axle assembly question - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
aluminum axle assembly? | Jerry3567 | Newbie General | 48 | 08-02-2010 09:26 PM |
axle assembly help | oilylizard | Axial SCX-10 | 6 | 09-22-2009 08:48 PM |
Axle Assembly Conversion | PDXFNG | Venom Creeper | 2 | 04-24-2009 01:06 PM |
Axle upright assembly | Mesozoic | Tamiya CR-01 | 4 | 06-21-2008 01:59 PM |
Axle Re-Assembly Issues | Mad Scientist | Tamiya TLT Crawlers | 5 | 05-28-2007 08:41 PM |
| |