Shocks to use when removing the cantilever setup

[Welderman85]

Hello all I picked up two used cr01s. I tore them both down for rebuilding. One is going to be stock the other I have been thinking of ditching the cantilever. I like the the look of the internal spring shocks but un sure if brands and length. I would like it a little lowered. Both trucks will be more trail / basher trucks than crawling. Than you

[OSRC]

Lots of options there, really could go on all day.

Best place to start is to set the truck to the ride height you want, measure the distance between the 2 mounts you plan to use, and then find that size shock. Usually come in 10mm increments - 70mm, 80mm, 90mm, etc.

I use Gmade shocks on one of my rigs - 90mm, though 80mm is probably a better fit. I've made some standoffs that bolt to the chassis to give me a few more options as far as shock lengths. You're kinda limited to shorter shocks just using the holes in the chassis.


Better look at the standoff, this time with a coilover shock. Just some scrap aluminum drilled to match the existing holes in the chassis.


OR go full bore fun and cut off the cantilevers and do a divorced coil setup.


Hope that gives you some ideas!

[Welderman85]

Thank you for the Ideas I think I will try the last one first. I have a few questions in the third pic are those stock shocks and how did you space them out from the frame. Thank you