Stampede Slider Shaft Question
 

Hi, I read some FAQs and still not quite getting a clear answer. I have a Stampede tranny and a stock TLT axles. Can I just bolt on the Stampede slider shaft? If not what I parts I need to make this a bolt on? Just starting this hobby so sorry if this had been asked a lot of times already.

Jeff

The stampede shafts will work just as they are, no mods needed. I would suggest using the steel outdrives with the sliders. I have them on my comp rig, TLT axles with an Axial trans and have not broken any all season.....

I run this exact same system in my rig I use steel outdrives and the axial yoke collars and I haven't snapped one yet

Thanks will give that a try.

Jeff

To run stampede yokes (either plastic or metal) with TLT axles, you will need to shave down the lip on the yoke that bolts to the axle pinion gear. The shafts will, of course, bolt up to the tranny without issue.