04-24-2009, 01:26 AM | #1 |
RCC Addict Join Date: Mar 2009 Location: hawaii
Posts: 1,139
| tlt bevel gear ????
does anyone know how wide the bevel gear shaft is on the tlt?
|
Sponsored Links | |
04-27-2009, 04:22 PM | #2 |
Rock Crawler Join Date: Sep 2006 Location: Lititz
Posts: 787
|
Wide? The bevel gear is 13.5mm in diameter. The shaft is 5mm in diameter. The overall length is 25.4mm. Hope that helps. Rob |
04-27-2009, 10:15 PM | #3 |
RCC Addict Join Date: Mar 2009 Location: hawaii
Posts: 1,139
|
ok, so the mip axial drivsshaft should fit on it then?
|
05-06-2009, 08:15 PM | #4 |
Quarry Creeper Join Date: May 2008 Location: Out in the country
Posts: 352
| I run the mips I run the MIP's on my comp rig. I love them and will NOT go back to plastic shafts. Here's a tip: Remove the "e-clip" that holds the bushing/bearing in on the output shaft. It will not affect anything, and it will relieve the bind that the MIP shaft puts on the output shaft. If you have any question s on this, shoot me a PM. Good Luck & Happy Crawling |
05-08-2009, 12:39 PM | #5 |
Rock Crawler Join Date: Sep 2006 Location: Lititz
Posts: 787
|
Yes, the axial and tlt pinion shafts are both 5mm.
|
Thread Tools | |
Display Modes | |
| |