| |
05-19-2010, 07:47 PM
| #1 |
| Newbie Join Date: Feb 2009 Location: glenpool
Posts: 9
|  tlt hex's and pins
HI, just picked up a custom tlt and it's missing the pins and hexes on the axles, i'm having a hard time locating these parts, can i use hexes and pins off of something else? Maybe axial? My other question is when you order links, is the measurement the length of the aluminum sleeve? Or the sleeve with the ends attached, like hole to hole? thanks
|
|  |
| Sponsored Links | |
| | |
|
05-19-2010, 08:03 PM
| #2 |
| I wanna be Dave Join Date: Jan 2006 Location: Henderson/Las Vegas, NV
Posts: 5,032
|
If you're ordering axial links, the length is just the rod its self. If they're labeled as 91mm or 109mm, they're referring to the length of the aluminum piece. Yes you can use axial hexes, or mip, or rpm or any other for that matter. All the 12mm hexes out there are pretty much the same. |
|
| |
|
05-19-2010, 08:33 PM
| #3 |
| Newbie Join Date: Feb 2009 Location: glenpool
Posts: 9
|
Ok thank you
|
|
| |
|
05-20-2010, 12:21 PM
| #4 |
| Quarry Creeper Join Date: Mar 2006 Location: Lutz
Posts: 457
|
You can use also the older Tamiya hexes off like a TA01,02,03 chassis also. Sometimes you can also find them the hexes in aluminum also. Just a little info.  |
|
| |
|
05-20-2010, 03:25 PM
| #5 |
| Newbie Join Date: Feb 2009 Location: glenpool
Posts: 9
|
Thanks, i ordered some hexes from an axial..I'm not real sure what chassis i have here, and i'm missing a driveshaft, which i can't find another one like it. After doing some reading i think i'm going to change over to a pede or axial tranny, i think parts might be easier to find if i do that. Any thaughts?  |
|
| |
|
05-20-2010, 11:27 PM
| #6 |
| I wanna be Dave Join Date: Jan 2006 Location: Henderson/Las Vegas, NV
Posts: 5,032
|
Kinda looks like an old junfac chassis. I don't know much of anything about them, but I know am axial trans would be your best bet.
|
|
| |
 |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
