|
| LinkBack | Thread Tools | Display Modes |
12-09-2004, 06:26 PM | #1 |
owner, Holmes Hobbies LLC Join Date: Nov 2004 Location: Volt up! Gear down!
Posts: 20,290
| check out these motors for a mini G crawler http://www.robotcombat.com/marketplace_ant_motors.html the mounting holes are narrower than your typical 280, but the 3mm output shaft deals would work quite well with a bit of thinking. hmmmm, how about a 3 cell lipo powered crawler. hmmm. but it might be a touch slow, especially with a mini t tranny. who knows the mini t tranny ratio, and the VMG axle reduction? isnt the VMG like 3.5 and the mini t around 3? |
Sponsored Links | |
12-09-2004, 08:18 PM | #2 |
Pebble Pounder Join Date: Nov 2004 Location: Charles Town
Posts: 112
| Re: check out these motors for a mini G crawler
check out the servos section, the first servo the have hitec HSR-5995TG Features: - Dual ball bearings - Ultra hardened shaft - 3 metal shaft bushing - Dual axial mount - 180° operating angle - Position Data feedback - Water & Dust tight - Metal output and servo horn - Pivot point on rear, inline with output gear HSR 5995 TG SPECS: Length: 1.57" Width: .78" Height: 1.45" Weight: 2.18 ounces Voltage: 4.8 - 7.2V Torque: 333.29 oz/in @ 6.0V, (417 oz/in @ 7.2V) Operating speed: .15 sec/60° @ 6.0V 417 oz/in at 7.2V 8O |
12-09-2004, 08:22 PM | #3 |
RCC Addict Join Date: Nov 2004 Location: Redding, CA
Posts: 1,288
| Re: check out these motors for a mini G crawler
that motor is pretty cool ight have to re think my second mini giant |
12-09-2004, 08:25 PM | #4 |
Pebble Pounder Join Date: Nov 2004 Location: Charles Town
Posts: 112
| Re: check out these motors for a mini G crawler look at the tires! |
12-09-2004, 08:44 PM | #5 |
Pebble Pounder Join Date: Nov 2004 Location: Charles Town
Posts: 112
| Re: check out these motors for a mini G crawler
gah, why did you have to post this site?!? http://www.robotcombat.com/marketplace_ant_pneu.html pneumatic steering anyone? |
12-09-2004, 10:45 PM | #6 |
owner, Holmes Hobbies LLC Join Date: Nov 2004 Location: Volt up! Gear down!
Posts: 20,290
| Re: check out these motors for a mini G crawler
i know, i have been ooogling that site for a few hours tonight. http://www.botparts.com/marketplace_...ntrollers.html this is what i have been looking at. a 6 to 50 volt 10 amp esc for 65 bucks!! you could make something serious with that. with all the stuff on that site. have i opened up a can of worms?
|
Thread Tools | |
Display Modes | |
| |