More Steering??? I have these axles under a custom build I had bought but it has zilch for steering radius before the knuckles hit the axle housing. Is there any way at all to improve the steering to these? http://www.tracgear.com/product/rc4w...using/g6/3.jpghttp://www.tracgear.com/product/rc4w...using/g4/4.jpg |
Re: More Steering??? RCP CVDs and max clearance knuckles as well as some of the Jones clocked C's: TLT*Axles*::*RCP*Crawlers |
Re: More Steering??? Quote:
X2. With alum or stainless "C's", you might see even the high clearance link hit the corners. So on the front alum axle casing you have, you might install a knuckle and see where it hits the case, then remove al ittle material in that area with a dremel or file. If it's on a 1.9 or smaller scaler, you can remove a little from the arm also. Unfortunately with the TLTs splined dif/shafts, MIPs are the only way to go with TLT front axles for more steering. |
Re: More Steering??? |
Re: More Steering??? Make sure your servo horn/arm is long enough. On my Axial, I had to get a longer arm to get more throw. |
Re: More Steering??? here's what you need for your TLT axles TLT*Axles*::*RCP*Crawlers I will have the clock "C's" restocked soon |
All times are GMT -6. The time now is 10:22 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com