newbie to shaftys.
 

Ive had a few MOA crawlers but I have just finished my first shafty. My question is is their anything I can do about the torque roll do you just have to learn to drive around it?

here is a few pics of my build. I'm running TLT axles, AX10 trany, and a traxxas brushless set up. The center skid is from the AX10 kit and the triangle side plates for the chassis were part of an old clobbuster chassis that i built hince the big oval hole where the battery used to slide in.

http://i40.tinypic.com/ear1ht.jpg

http://i43.tinypic.com/2iblpi9.jpg

http://i40.tinypic.com/33x9f12.jpg

http://i40.tinypic.com/2uyq72u.jpg

http://i42.tinypic.com/21nnono.jpg

http://i42.tinypic.com/13za52a.jpg

Re: newbie to shaftys.
 

i had a bad problem with torque twist on my axial i ended up throwing heavier shock fluid in the right rear to help it out doesnt fully stop it but it sure helps to slow it down