RCCrawler Forums

1beatjeep · 01-07-2007, 10:16 PM

i was at the HAMMER local to me and this is what happen.pionnoin fell off in case.

Natedog · 01-07-2007, 10:56 PM

Oh crap, I haven't seen that before. How about some Loctite wicking type applied before installation? Otherwise maybe good to press off, apply Loctite Sleeve Retainer and press it back on?

toyota_yes_please · 01-07-2007, 11:06 PM

I've had this happen twice. The pinion slides off the end of the shaft. I think it's cause they were shimmed to tight but the gear mesh sure was nice. Any way just tap it back on there (don't damage the teeth) and ad some ca glue, that should hold it for awhile.

01-07-2007, 10:16 PM	#1
1beatjeep I wanna be Dave Join Date: Aug 2004 Location: san jose Posts: 2,061	how many has this happen too. i was at the HAMMER local to me and this is what happen.pionnoin fell off in case.

01-07-2007, 10:56 PM	#2
Natedog I wanna be Dave Join Date: Jan 2006 Location: Corruptifornia Posts: 12,107	Oh crap, I haven't seen that before. How about some Loctite wicking type applied before installation? Otherwise maybe good to press off, apply Loctite Sleeve Retainer and press it back on?

01-07-2007, 11:06 PM	#3
toyota_yes_please Pebble Pounder Join Date: Dec 2005 Location: Knoxville Posts: 169	I've had this happen twice. The pinion slides off the end of the shaft. I think it's cause they were shimmed to tight but the gear mesh sure was nice. Any way just tap it back on there (don't damage the teeth) and ad some ca glue, that should hold it for awhile.

Sponsored Links

RCCrawler Forums

Thread: how many has this happen too.