trying the revo shaft swap and I need help.new problem added
 

Im trying to do the revo shaft swap but I need help.. I am not seeing the way the end of the shaft goes into the transmission.. Does anybody have pics of this or can explain... I know the open end goes on to the gearbox part., but the shaft that sticks outs , what do I do with it...

Please help!!!!! :cry: :?


UPDATE: OK I got them on.... I am running the stock 4 link and now I have a problem with the shaft hitting the upper 4 link ...any suggestions guys?? what did you guys do to remedy this???

thanks again for any info....

Re: trying the revo shaft swap and I need help....
 

take that pin out and it will slip right over either output shaft.

Re: trying the revo shaft swap and I need help....
 

Been some good talk about it over at RCMT.... yeah I know linking to another forum is bad but freakin' A.. there is good stuff there too.....
:flipoff:

http://p083.ezboard.com/frcmtnet4499...cID=1131.topic

Re: trying the revo shaft swap and I need help.new problem a
 

Badger is running maxx shafts but he had the same issue. He bent the link to clear the shaft.

Re: trying the revo shaft swap and I need help.new problem a
 

Take the upper link that is hitting the shaft and mark it with something (pen, exacto). Then put the link in a vise and take a hammer to it until you get the amount of bend you need. It does not take much.

Re: trying the revo shaft swap and I need help.new problem a
 

If that does not work get a bigger Hammer :lol:

Re: trying the revo shaft swap and I need help.new problem a
 

welp, I had to used the bigger hammer...its all done... man these thingss are beefy... I wish it was still my truck lol...... We will be testing it out hopefully today...

Re: trying the revo shaft swap and I need help....
 

But you have to be a member to see it. laaame :flipoff: Not that I have driveshafts anyway. But still :P