shims? are there any shims required on gear mesh for txt/jugg 2 axles. thanks in advance. |
Quote:
When I installed the differential with long and short shafts, I placed thin shims on opposite sides of the diff to take up any loose play. Tamiya tells you to place a washer on each end of the axle shaft, next to the c clip. I was able to move the diff side to side and wanted to eliminate that. Make sure you do not shim too tight just enough to take up the excess play. I also used a shim on the top right angle gears to keep the gears mesh consistant. Without the shim I found that the mesh was not consistant when turning by hand. I would imagine that in time as the gears wore, this movement can lead to excessive wear. I also used red locktite to hold the gear onto the splined shaft during assembly. I made sure that the gears turned freely without binding up. |
All times are GMT -6. The time now is 01:12 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com