servoe savers I will be upgradeing to quarter scale servoes and I dont know what to use as a servoe saver? I will be crafting some mounting plates out of some scrap aluminum I found and I want it to be tough enough to rock crawl with while still protecting the gears, or is that too much to ask? Should I just solid mount two cheap futabas or hobicos? like 35 bucks a piece? :lmao: an entire paragraph with question marks 8) |
Re: servoe savers I don't run any on mine. I've stripped a few servos that way but I just can't seem to find a strong servo saver that holds. Most people don't run them. |
Re: servoe savers Servo savers are bad and pointless if you use the right servo. Kimbrough 124 was decent, so was a Tamiya's stock servo saver with multiple C shaped springs added on top of the stock one. You could fine tune it and get it almost solid. |
Re: servoe savers I guess I will solid mount it then.. any suggestions on a good digital servoe? If I want to run two I guess I will need a BEC too. I dont even know what or how to wire one up O.o Work in progress, thats half the fun. I suppose. |
All times are GMT -6. The time now is 10:37 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com