Has anyone built an interior for a wrangler cc01?
 

So after completing the exterior of my cc01 wrangler, I had decided I want to build an interior for it. However, I don't know where to begin. I have purchased clear windows, and a driver for the jeep, but the steering servo has me at a stand still. I don't want to build a block around it, and chop off my drivers legs, like ive seen some people do. So I ask, has anyone built an interior for the wrangler? if so, please post pics. Thanks!"thumbsup"

Re: Has anyone built an interior for a wrangler cc01?
 

The wrangler with the CC-01 chassis or any body with that chassis, its tough to build a full interior. You could build a simple or detailed interior from styrene.


Before: NOTE, not a CC01 chassis but the chassis sits up high into the interior and this rig uses and axial tranny so a full interior isnt possible.
http://i466.photobucket.com/albums/r...p/IMG_6178.jpg

After: Half interior. Tamiya blackfoot driver with a different head. Styrene tube roll cage etc...
http://i466.photobucket.com/albums/r...psbf45666f.jpg
http://i466.photobucket.com/albums/r...ps527a8bb1.jpg
http://i466.photobucket.com/albums/r...ps9209d342.jpg
http://i466.photobucket.com/albums/r...ps6131959c.jpg

Re: Has anyone built an interior for a wrangler cc01?
 

The interior is basically just flat. It runs the length about where the hard top meets the body.

Re: Has anyone built an interior for a wrangler cc01?
 

thanks for the reply! I actually started on an interior for my cc01. I think its going to be great. I will post some pictures when its complete. I have Sam Fisher as my driver, and I wanted to make the interior fit him, without chopping his legs off.