|
| LinkBack | Thread Tools | Display Modes |
05-18-2014, 08:58 PM | #1 |
Newbie Join Date: Oct 2013 Location: east coast
Posts: 34
| bronze bushings for steering mod
So far anything I have seen to improve the steering has involved drilling or hacking up the chassis, Has anyone tried to use bronze bushings in the existing holes and fab a steering shaft from threaded rod? I'm considering giving it a shot but I have no idea what size bushings would fit. I was thinking about getting a gpm kit just for the metal bushings it has if I can find one state side. If anyone has a defective gpm kit donations are welcome click the link to see bushing sizes, if anyone knows what size would fit it will be greatly appreciated Bronze Bushings |
Sponsored Links | |
05-20-2014, 11:11 PM | #2 |
Quarry Creeper Join Date: Oct 2004 Location: Beckley
Posts: 288
| Re: bronze bushings for steering mod
The chassis can be drilled to accept a 5x10 bushing or bearing and use an m5x39.5mm shaft. Here is a link to the tutorial. Sorry if this doesn't embed; im using my phone. TamiyaUSA.com - Modifying the CC-01 Chassis By: Joe Anderson |
05-21-2014, 08:48 AM | #3 |
Rock Crawler Join Date: May 2008 Location: At the corner of Bedlam and Squalor.
Posts: 712
|
You might be better served by getting the GPM kit and using it. Careful assembly and using better fasteners goes a long ways.
|
bronze bushings for steering mod - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AR60 Pinion Bushings vs Bearings vs Bushings Thread | TheScaleAddict | Axial Wraith | 276 | 03-21-2018 11:27 PM |
Xirtic + JP High Clearance Steering Mod on Mod | JeffK11 | RC4WD Bully | 1 | 02-01-2012 09:55 AM |
VP Bronze Transmission Bushings | Pdog7 | Axial XR10 | 5 | 10-04-2010 04:29 PM |
Wk steering lever 1 bushings... NEED SOME! | JavelinSST390 | HPI Wheely King | 6 | 04-22-2008 01:10 PM |
Front Dig Mod,steering mod & pushbar | TheButcher69 | General Crawlers | 1 | 11-06-2006 06:32 PM |
Thread Tools | |
Display Modes | |
| |