CC01 Frame options
 

Looking to build a CC01. I m doing it because I am looking for a short wheel base IFS build. Im looking to get the servo up front. Thats the biggest thing holding me back. Are the any chassis conversions out there? Or anything?

Re: CC01 Frame options
 

i have a ta02 with a forward mounted servo it takes some custom brackets you have to be able to mount the bell.crank in front of the gear box
it moves the servo up higher on the chassie and over hanges alot out front
i mounted my bell crank to the front skid and the servo plate
i know its a different rig completely but all the front end parts are the same after the diff anyway
i know theres a better way of doing it look through the cc01 section i know ive seen it done before on the cc01 chassie

Re: CC01 Frame options
 

Search in the CC-01 threads, there are a few diys for steering setups.

Re: CC01 Frame options
 

What he said.

This might be a good start...

http://www.rccrawler.com/forum/tamiy...e-eyed-yj.html

There may be more threads with this kind of info...just try a search in the cc01 section for "Front mounted steering servo". Good luck. "thumbsup"

Re: CC01 Frame options
 

Thanks guys. Using this thread I decided to just relocate servo. What do you think?https://uploads.tapatalk-cdn.com/202...0c8096625c.jpg
https://uploads.tapatalk-cdn.com/202...0c8096625c.jpg
https://uploads.tapatalk-cdn.com/202...98b1287683.jpg


Sent from my iPhone using Tapatalk

Re: CC01 Frame options
 

Where's the servo?

Re: CC01 Frame options
 

i dont know were the servo is but i do see a big fricken brick hangin down on the front of this rig

i see a brick ectomy in your neer future

Re: CC01 Frame options
 

I was in the process of putting it up front as in the link above, Kind of pulled plug on the new Bronco build the 1/10 is too small the 1/8 is too big. Not sure whats next

Re: CC01 Frame options
 

i dont know witch one it witch but the one sitting on the chassie looks like it fits nicely
what dosent fit right on it