RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Tamiya XC/CC01 (http://www.rccrawler.com/forum/tamiya-xc-cc01/)
-   -   I need help (http://www.rccrawler.com/forum/tamiya-xc-cc01/624712-i-need-help.html)

kgb424 05-02-2021 09:19 PM

I need help
 
1 Attachment(s)
Can some one please tell me, the size of the E-Clips needed for the pins for the lower aluminum a arms for the CC01 ??, I waited over a month, for the a arms to come from China and they then shorted me 3 or 4 E-clips, I have no way to measure the diameter of pins or due you measure the diameter of groove of e-clip for the pins ??, the seller is not replying to me on Ebay where I ordered them, I will buy extra's if I can figure out the size of the clips

DRED805 05-02-2021 09:32 PM

Re: I need help
 
I would just order this, and hope for the best...


https://www.amazon.com/dp/B08N9G8ZMJ...ing=UTF8&psc=1

OSRC 05-03-2021 06:34 AM

Re: I need help
 
It's a 4mm shaft, so I assume 4mm e-clips would work.

nightcrawler48 05-03-2021 02:19 PM

Re: I need help
 
If the shaft is 4mm outside diameter, the clip size should be 3.2mm.

3.2mm is 0.125 inches so a 1/8 inch e-clip might work as well. Can't guarantee that though.

kgb424 05-03-2021 10:02 PM

Re: I need help
 
1 Attachment(s)
Thanks everybody for responding, I'm going to go with DRED805 suggestion and buy one of the kits, cause I also can use them on my Weber carb on Yoter, I lost one or two, the last time I rebuilt the carb and used my extra clips from Tamiya kits I built but don't have anymore, and have bought the bigger sized ones at Napa, so that also saves me a trip into town too if I have a kit

kgb424 05-13-2021 07:13 PM

Re: I need help
 
1 Attachment(s)
I got the E-clips kits, just have not had the time until right, and it confirms that I need reading glasses, cause I had my eyes tested and its hard to see small print and the e-clips were a pain in the ass, I could not see the grove to start the clip in position on the pin, but I got it done, and will go look at frames and get the Blue Light Blocking Coating, so I can also use them when gaming or online, I spend a lot of hours on my Desktop, and they will help my eyes and will be able see shit up close to build RC's, being struggling now I know why

Boomer75 05-19-2021 10:49 AM

Re: I need help
 
Just started needing readers so I feel your pain. I am still on store bought options which can be tough because apparently I have a wide head. I have also been using my phone for magnification and think it is finally time to purchase an eclip remover installer as the last project was pretty brutal when you add reduced vision to it.


All times are GMT -6. The time now is 10:30 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com