Micro dig servo ???
 

Ive heard of people using them Anyway just wanted to see whats the least amount of tq you need to do the job and cut some weight ? Is there anyone that makes a lcg servo mount for a micro?"thumbsup"

I've had very good luck using a micro..However I'm switching back to mini's. Mostly cause I'm trying out Crawler Designs new mount. I was using a HS-85MG I think its some where close to 49oz at 6v. I'm currently running 7.4v to both my servo's :twisted:, both seem to take it well. I've heard of Losi Drivers using the HS-65HB...could be wrong though. I wouldn't use nothing less than the 82, 85 or the 5085

Also, it's very easy to mount in the stock location. Just re-drill the furthest to the back mount closer to the front of the trans case. I did make and using a Rcbro knock-off LCG micro mount. Works well but has more flex than I'm wanting. Used 3/16 delrin. Weighed 6g I think

I've been using the same 85mg since the lcc came out."thumbsup"

I've been using a Hitec HS-85 too and it has been working fine on top of the tranny in the stock location. Takes a little bit of work to get it up there, but not much. I wouldn't go less than this. I do notice on occasion that it doesn't shift quite as quickly as my other servo, but it works well 98% of the time.