RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Team Losi Comp Crawler (http://www.rccrawler.com/forum/team-losi-comp-crawler/)
-   -   Worm Gear Axles On A Gen7 Pro (http://www.rccrawler.com/forum/team-losi-comp-crawler/619877-worm-gear-axles-gen7-pro.html)

Snowman110011 07-20-2020 09:38 AM

Worm Gear Axles On A Gen7 Pro
 
I have a Gen7 with 18t Pinion and 50t spur 32p, was wondering how it would perform swapping the portals out for the Worm Gear Axles?

Anyone tried this?


Sent from my iPhone using Tapatalk

ferp420 07-23-2020 07:25 AM

Re: Worm Gear Axles On A Gen7 Pro
 
just talkin out my back side here but im guessing the speed would go down and th3 maintanance will go up you might have some driveshaft issues im not sure what outputs losi used on there axles other than that im guessing your good to go

nismotuningrocks 07-23-2020 10:26 AM

Re: Worm Gear Axles On A Gen7 Pro
 
I believe the Losi Night crawler and comp crawler trans are right around 1:1-1.5:1 so depending on the gearing on the redcat trans you may have some ridiculously low gearing.

Snowman110011 07-27-2020 11:13 PM

Re: Worm Gear Axles On A Gen7 Pro
 
I tried it on an E10 and even gearing up it was still way to slow lol


Sent from my iPhone using Tapatalk


All times are GMT -6. The time now is 03:40 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com