|
![]() |
| LinkBack | Thread Tools | Display Modes |
![]() | #1 |
Newbie Join Date: Oct 2019 Location: IAEGER
Posts: 19
| ![]()
I have a Gen7 with 18t Pinion and 50t spur 32p, was wondering how it would perform swapping the portals out for the Worm Gear Axles? Anyone tried this? Sent from my iPhone using Tapatalk |
![]() | ![]() |
Sponsored Links | |
![]() | #2 |
I wanna be Dave Join Date: Jan 2016 Location: california under the rock im crawling on
Posts: 3,008
| ![]()
just talkin out my back side here but im guessing the speed would go down and th3 maintanance will go up you might have some driveshaft issues im not sure what outputs losi used on there axles other than that im guessing your good to go
|
![]() | ![]() |
![]() | #3 |
Quarry Creeper Join Date: Jun 2009 Location: Winchester
Posts: 242
| ![]()
I believe the Losi Night crawler and comp crawler trans are right around 1:1-1.5:1 so depending on the gearing on the redcat trans you may have some ridiculously low gearing.
|
![]() | ![]() |
![]() | #4 |
Newbie Join Date: Oct 2019 Location: IAEGER
Posts: 19
| ![]()
I tried it on an E10 and even gearing up it was still way to slow lol Sent from my iPhone using Tapatalk |
![]() | ![]() |
![]() |
![]() | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Love/Hate my Gen7 Pro - will portal axles rekindle? | rayraypc | Redcat Crawlers | 4 | 08-11-2019 08:01 AM |
Non worm gear axles for a go fast rig | twomicros | Micro Scale Rigs | 10 | 06-29-2019 09:00 AM |
Thread Tools | |
Display Modes | |
| |