| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
12-25-2019, 07:55 PM
| #1 |
| Rock Stacker Join Date: May 2019 Location: Upstate, NY
Posts: 96
|  Gmade Beadlocks/Nut Driver
Assembled a set of Gmade SR02 Beadlocks. The 'lug nuts' are 2.5mm x 8mm hex bolts. Each pair comes w/ a socket for the 2.5mm bolts driven by a 2.5mm hex driver. I have a Wiha metric nut driver set and tried using one instead of the socket. The 2.5mm is too small while the 3mm is too big. Anybody know what size nut driver does fit? |
|  |
| Sponsored Links | |
| | |
|
12-30-2019, 09:48 AM
| #2 |
| Quarry Creeper Join Date: Sep 2015 Location: Bakersfield
Posts: 219
| Re: Gmade Beadlocks/Nut Driver
I use MIP tools and have never had a problem with the SR series of wheels. Is it like that with the adapter that came in both pairs?
|
|
| |
|
12-30-2019, 10:21 AM
| #3 |
| Moderator   Join Date: Sep 2008 Location: PA
Posts: 13,935
| Re: Gmade Beadlocks/Nut Driver
I've found the same. I believe they are 2.75mm. Good luck finding that elsewhere.
|
|
| |
|
01-03-2020, 07:09 PM
| #4 |
| Quarry Creeper Join Date: Dec 2016 Location: Toronto
Posts: 210
| Re: Gmade Beadlocks/Nut Driver
Measured with caliper the lugs are 3.3mm at the largest point. The adaptor/driver they come with measures 3.5mm
|
|
| |
|
Gmade Beadlocks/Nut Driver - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Small Nut Driver Suggestions | IronGut | Tools, and Procedures | 11 | 05-20-2015 08:16 PM |
| |
Linear Mode
