post your procedures for holding parts?? Please post how you guys are holding parts while brazing? |
Well,I don't do any brazing but when welding little parts I sometimes use little bench vises. You can get tiny bench vises(like 2 or 3" jaws) at most hardware or tool supply stores. |
Tack it with a mig then braze it to make it look nice. :mrgreen: |
small tack with a mig, then braze, then grind with a dremel to get off the flux and to grind the tack down a bit |
Hot water will clean that flux off. Otherwise the chassis will be all sticky/gummy after a while. |
I use welding magnets, bailing wire, little c-clamps, and scraps of steel sheet or other pieces as needed. Jay |
All times are GMT -6. The time now is 02:01 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com