Acramill/ Lathe Has anyone tried his dremel mill? to machine some delrin.http://vanda-layindustries.com/html/acra_mill_plus.html They use it for the model ship hobbyist. |
Hmmmm I have not seen this one before I might have to try it out. Steve |
You know with the higher powered 400 dremel. I think it could do some good work with some delrin projects. |
What I was thinking is to use it with a bench grinder with a flex shaft. http://pictures.kyozou.com/pictures/_3/2573/2572077.jpghttp://vanda-layindustries.com/asset...nd_piece_3.JPG |
You think it will work? Where would you mont flex shaft? |
Quote:
Steve |
The grinder flex shaft idea is a good one IMHO. |
grinder flex shafts work great for milling on stuff!!;-) |
I was just searching through posts researching lathes, and ran across across this thread. The link in the first post made me laugh....................Vanda-Lay Industries??:lol: :lol: Cosmo Kramer: [phone rings, Kramer picks up the phone] Hello... What Delay Industries? George Costanza: [yelling from the bathroom] Vandelay! Say Vandelay! Cosmo Kramer: No, you're way, way, way off. Well yeah, that's the right number, but this is an apartment. George Costanza: [rushes out of the toilet with his pants on his knees] Vandelay! Say Vandelay Industries! [falls down] Cosmo Kramer: Yeah, no problem. [hangs up phone] |
it looks pretty well built |
All times are GMT -6. The time now is 08:45 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com