RCCrawler Forums - Welders will get a kick out of this

RCCrawler Forums (http://www.rccrawler.com/forum/)

- Tools, and Procedures (http://www.rccrawler.com/forum/tools-procedures/)

- - Welders will get a kick out of this (http://www.rccrawler.com/forum/tools-procedures/615866-welders-will-get-kick-out.html)

JacktheRipper

02-22-2020 04:17 PM

Welders will get a kick out of this

1 Attachment(s)

You know, some times a close pin clamp will just not work.

pep

Lashlee

02-24-2020 10:02 AM

Re: Welders will get a kick out of this

Sometimes you've gotta use whatever you can to make it work! I've used a combination of magnets stacked up before to weld tabs on, and that was sketchy at best!

DrewKlant

03-04-2020 05:11 AM

Re: Welders will get a kick out of this

Hey, as long as it works, there's no shame in it. An ingenious solution, btw!

All times are GMT -6. The time now is 04:43 AM.