5.5mm and 7mm the only nut drivers you will need? I have a SCX10 OG RTR and noticed that I only need 5.5mm and 7mm nut drivers for maintenance. I just got a Capra kit and haven't even touched it yet due to life. :) Does the same apply? Basically all I need is 5.5mm and 7mm for nut drivers? I already have a set of MIP hex drivers from my RC helicopter days. Trying to minimize my tools or should I just get the Dynamite metric nut driver set and be done with it? If just the two sizes I was going to go Wiha. |
Re: 5.5mm and 7mm the only nut driver you will need? Sizes , yes but remember there are always a few nuts that the drivers are too long for. , then it’s needle scaring nose pliers or a set of flat wrench’s, WIHA tools are top notch for me Hang up and Drive |
Re: 5.5mm and 7mm the only nut drivers you will need? Thanks! I already have a set of Sears mini open ended and box wrenches in mm sizes. A very nice set and I don't think they make them any more. They were Made in USA. Those were the days! :D |
Re: 5.5mm and 7mm the only nut driver you will need? I was going to suggest getting a 5.5mm open ended wrench instead of a 5.5mm nut driver because I use the open ended wrench about 10 times more than a driver on M3 nuts. Actually looking at my Capra, it has almost no (and it may be zero) M3 nuts so a 5.5mm wrench isn't really needed to build one. |
Re: 5.5mm and 7mm the only nut driver you will need? Quote:
EDIT: you're right! Looking on the PDF I found zero M3 nuts. Saved me some $$$. :) |
All times are GMT -6. The time now is 01:27 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com