RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)

- Tools, and Procedures (http://www.rccrawler.com/forum/tools-procedures/)

- - Torch (http://www.rccrawler.com/forum/tools-procedures/89320-torch.html)

Bigman

10-22-2007 05:39 PM

Torch

For brazing can i just use a MAAP torch? Is the MAAP with the oxygen better for it?

What rods are best for steel?

joehein

10-25-2007 09:54 AM

i have mapp brazed. it works good take a little time to heat but not bad. im not really sure about the oxygen being better or worse though

Renslipevol

10-27-2007 11:20 AM

If the parts being brazed are small, you may heat them up to a too high of temp. Just be careful as to where your flame is pointed and how far away the flame tip is to your work.

Mike-63

11-07-2007 09:28 PM

I use a MAPP torch and it works great, at work I tried using the OXY and MAPP torch and I was overheating the brake line. If you choose to go with the MAPP and you use one of those little hand held bottles I found it best to keep the work about one inch from the tip of the nozzle.

All times are GMT -6. The time now is 07:57 PM.