What size drill bit to make rocksolids fit tlt cvd's? I have tlt cvd's, and i need to know what size drill bit i need to make my rims fit. Thanks Tyler |
I have CVDs and my RockSolids Top Guns fit without drilling. |
What do you need to drill, if the wheel is a 12mm hex they should fit right on. |
The hole that the axle shafts go through The cvd's are to big to fit. Just need to know what size bit. I must apologize, they are the copies made by drastic sports. You see, when i purcased them, I was unaware what was going on with all of that. I thought it was the same company. Had I known then that they were a copy of another man's design, I would have given Unimoger my money. Sorry in advance, and thank you for your help. Tyler |
If a hole is too small, use a bit the same size as what your trying to fit in it. Isn't that fairly obvious? |
you sir are correct. I just didnt want to go to big and wondered if someone else had done it and what size they used |
The outer axles on the TLT CVD's are .235 diameter, so a 1/4" drill should work fine. |
Who needs a ruler with Bender around? "thumbsup" |
Quote:
|
All times are GMT -6. The time now is 02:22 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com