RCCrawler Forums

PEDEcrawlerguy · 03-16-2008, 02:18 PM

i was lookin at sfrankland's way of using oversize washers, and rod, to make custom axles... i know i need a washer with an id of atleast 1.021" to go on diffs... but what about the OD.. do you think something around 1.75 will work ok, and give me enough room to fasten the rods to....

any one who has used a method like this.. please LMk what size you have used

666 · 03-16-2008, 03:05 PM

Get a 1/2" washer.

03-16-2008, 02:18 PM	#1
PEDEcrawlerguy Rock Crawler Join Date: Jul 2007 Location: clearfield Posts: 678	what size washers to use to make maxx axles i was lookin at sfrankland's way of using oversize washers, and rod, to make custom axles... i know i need a washer with an id of atleast 1.021" to go on diffs... but what about the OD.. do you think something around 1.75 will work ok, and give me enough room to fasten the rods to.... any one who has used a method like this.. please LMk what size you have used

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-16-2008, 03:05 PM	#2
666 MODERHATER™ Join Date: Nov 2005 Location: Colorado Posts: 10,939	Get a 1/2" washer.

Sponsored Links

RCCrawler Forums

Thread: what size washers to use to make maxx axles