TRX4 Truggy body 1 Attachment(s) This started off as a TRX4 Defender. Its been one of my stay occupied projects, so its got just about all the brass parts, axles, upgraded servos etc. The electronics are all still stock. The body is Proline Superduty with the trail honcho back half. I 3D printed a hinge at the back of the cage and the body is magnet mounted at the front. I 3D printed a grill insert, and headlight buckets that I painted with chrome paint, didn't install the headlights yet...and then went out played with it and rolled it down some rocks, so its not quite this pretty anymore. |
Re: TRX4 Truggy body I forgot to add, the lower body is painted with bedliner, and i 3D printed some spacers to relocate the rock sliders up a bit higher, and a little narrower. |
Re: TRX4 Truggy body Looks good what file did you use for the rear cage pivot ? |
Re: TRX4 Truggy body Quote:
I’ll post a picture, it slides into the rear frame rails in place of a bumper, it has provisions for lights too |
Re: TRX4 Truggy body 1 Attachment(s) my hinge |
Re: TRX4 Truggy body Looks good how you holding the cage in ? |
Re: TRX4 Truggy body Quote:
|
Re: TRX4 Truggy body Quote:
Sent from my LM-V600 using Tapatalk |
All times are GMT -6. The time now is 04:46 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com