original old e-maxx

[scarecrow]

I have 2 original e-maxx`s 1 of the 2 does not run the esc is smoked. is there a esc out there that will bolt in and go? I would like to run lipos if that is possible. both trucks have stock electronics.

[syp]

You vould buy the new evx that has lvd or you could buy a brushless system for more speed and power, kershawdesign is an option or any other hobby shop. But depends how much money you will spend.

[makya]

I know this has been up for awhile, but I thought I'd post this up for reference. the hobbywing quicrun wp-860 is a dual brushed motor esc that will drop in to an emaxx, and can be bought for about $40.

[l36pontiac]

to run lipo on the old 3906 u can trade in the old esc for a new one via traxxas lifetime warranty. i did on mine runs great. with 2s lipo it likes to snap drive shafts

[cobaltracer1986]

id say your good to run lipos with any esc, i have been running a lipo on an old dynamite tazer esc for a little over a eyar now with no problems, i think it was out before the lipo craze, just get a voltage sensor, the bro and i use a low voltage buzzer on his crawler since theres no lipo cut

[MD ENFORCER]

Originally Posted by makya

I know this has been up for awhile, but I thought I'd post this up for reference. the hobbywing quicrun wp-860 is a dual brushed motor esc that will drop in to an emaxx, and can be bought for about $40.

I just bought a newer evx-2, and has been working fine on two 5000mAh 2S Lipos.

I installed mine on a 3906 e-maxx.