K10 body, bobbed frame I just figured i'd share my build. I really like this body. It's one of my favorites. I really like this trx-4. it's one of my favorites... lol So i used the stock body posts from the TRX4 up front. i just made 2 new holes in the body. In the rear i used the stock vaterra posts that would go down into the vaterra chassis. I drilled 2 horizontal holes through it and ran longer rear shock mount bolts through them and created a hinge setup. https://i.imgur.com/qnSRGgG.jpg https://i.imgur.com/HKCIl9j.jpg In the rear (test fitting here) the chassis was a lot longer than on the ascender. https://i.imgur.com/sUNPIso.jpg Sooooooooooo https://i.imgur.com/gZ995Ga.jpg https://i.imgur.com/43SCB0M.jpg That's the result. I think it turned out nice. The only other things i've changed are: MFR brass portal covers MFR tie rod MFR lower links Savox 500oz servo NO brainer BEC Raceline beadlocks Alien compound pitbull rocker XL's This thing just works. |
Re: K10 body, bobbed frame The Ascender K10 truggy body is a cool one, aaand Its nice to see it fit over the TRX4. Great combo dude! |
Re: K10 body, bobbed frame Quote:
|
Re: K10 body, bobbed frame That looks really good |
Re: K10 body, bobbed frame Quote:
|
Re: K10 body, bobbed frame Quote:
|
Re: K10 body, bobbed frame Quote:
|
All times are GMT -6. The time now is 10:16 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com