| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
03-07-2018, 12:52 PM
| #1 |
| Pebble Pounder Join Date: Mar 2017 Location: Southern Maine
Posts: 122
|  TRX4 using 8028 module where can i install on/off switch?
TRX4 using 8028 module installed per traxxas instructions but would like to wire in a small manual spst switch and have the option of on/off lights . It appears the signal wire turns on the module. Any ideas ? edit:It is the center + pin that can be interrupted to turn on/off module. I just tried it. Last edited by willygee; 03-07-2018 at 06:58 PM. |
|  |
| Sponsored Links | |
| | |
|
TRX4 using 8028 module where can i install on/off switch? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Light Switch for Your Scaler - Firmtronics RC Switch Review | roktoy | Electronics | 29 | 09-15-2015 02:37 PM |
| Wiring a switch to switch polarity | builder | Electronics | 5 | 05-20-2013 07:55 PM |
| switch wiring for power, do u switch - or + | toy4crawlin | Electronics | 3 | 09-09-2008 04:59 AM |
| How to install switch for winch? | Norcal crawler | Electronics | 2 | 11-20-2007 09:53 PM |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
