|
| LinkBack | Thread Tools | Display Modes |
03-21-2018, 09:55 PM | #1 |
RCC Addict Join Date: Feb 2010 Location: New Jersey shore
Posts: 1,482
| going brushless. Few problems
the bought mamba Max Pro and trackstar motor and for steering a hitec servo rated at 6v 333 ounces of torque.it's not exactly what I wanted with the price was right. I got everything installed along with a BEC. I'm not too familiar with traxxas radios. I put the BEC in the very top channel. Disconnected the red wire on the mmp. power it up the three small servos move back and forth. servo and esc work sometimes. any ideas? didnt plug it back in and blow something up. any ideas thanks. |
Sponsored Links | |
04-17-2018, 07:04 PM | #2 |
Newbie Join Date: Feb 2017 Location: On the road..
Posts: 27
| Re: going brushless. Few problems
I don’t have my rx handy, but you’ll want to go into the second port for ch1 on the traxxas rx with the bec. I think the top port might be for the telemetry sensor, and I don’t know that it’s all “well connected”. I remember doing something similar to this I think eh past
|
going brushless. Few problems - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wheel problems after going brushless | MissouriWKmodder | HPI Wheely King | 2 | 06-13-2015 11:02 AM |
Brushed to brushless problems | jeepnvinny | Electronics | 4 | 01-26-2014 08:24 PM |
snesored brushless problems | idk | Electronics | 2 | 02-06-2013 06:30 PM |
Problems with Losi Micro brushless system | megaherz | Non Crawler RC's | 3 | 10-26-2010 11:15 PM |
Spektrum/Brushless Problems | crawlaholic | Electronics | 8 | 04-02-2007 03:13 PM |
| |