RCCrawler Forums - Full size shift servo mounting.

RCCrawler Forums (http://www.rccrawler.com/forum/)

- Traxxas TRX-4 (http://www.rccrawler.com/forum/traxxas-trx-4/)

- - Full size shift servo mounting. (http://www.rccrawler.com/forum/traxxas-trx-4/605765-full-size-shift-servo-mounting.html)

bbrigg

01-23-2019 06:36 AM

Full size shift servo mounting.

I have just swapped out the micro shift servo replacing it with a cheap waterproof full size servo. It works fine but the whole plastic part that the ESC sits on flexes when I shift gears. The servo is a 15kg type but I'm still using the stock "servo saver" from the original micro servo. The original servo actually mounts to the transmission. Does anybody have any ideas on mounting this more solidly?

Sent from my LG-H870DS using Tapatalk

BashNSlash

01-23-2019 07:29 PM

Re: Full size shift servo mounting.

I'm following this thread because I'd love to know more about this [emoji108] Sub micro servos are hard to find and more expensive than full size servos, so if this can be done reliably, I'll probably go this route when it's time to replace those.

Sent from my SM-N950W using Tapatalk

o0wiz0o

01-25-2019 03:00 PM

Re: Full size shift servo mounting.

Hi folks. I used the servo mounting tabs from axial. If you have a nosy at the pics in the link in my signature they are in there somewhere. Easy to do and lasted a long time.

All times are GMT -6. The time now is 01:06 AM.