RCCrawler Forums

dbedit · 06-22-2016, 06:10 PM

I am going to run Associated Big Bore 12mm on PRT Chassis should I run a front and rear or two rear length shock sets?

Del Monte · 06-23-2016, 12:13 AM

Quote:

Originally Posted by dbedit

I am going to run Associated Big Bore 12mm on PRT Chassis should I run a front and rear or two rear length shock sets?

I'm running the rear length Proline shocks on mine. I believe that most PRT's I've seen run the same length shock front and rear.

altd896 · 06-23-2016, 03:22 AM

Usually SCT rear run on both ends.
My 1.9PRT runs the 103mm Traxxas XXL big bore shocks with Axial 14x70 springs, just can't remember off hand if purple or orange.

Have checked, got purple stripe springs on

06-22-2016, 06:10 PM	#1
dbedit Newbie Join Date: Dec 2009 Location: Athens Posts: 13	UC FAB PRT Question I am going to run Associated Big Bore 12mm on PRT Chassis should I run a front and rear or two rear length shock sets? Last edited by dbedit; 06-22-2016 at 07:06 PM.

06-23-2016, 03:22 AM	#3
altd896 RCC Addict Join Date: May 2013 Location: Forrestfield, Western Australia Posts: 1,082	Re: UC FAB PRT Question Usually SCT rear run on both ends. My 1.9PRT runs the 103mm Traxxas XXL big bore shocks with Axial 14x70 springs, just can't remember off hand if purple or orange. Have checked, got purple stripe springs on Attached Images Last edited by altd896; 06-23-2016 at 04:45 AM.

UC FAB PRT Question - Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Grip Fab locker question	wraithfreak	Axial Wraith	7	01-19-2015 06:16 PM
My trekker project prt 1 this is wat it started as	microNthuzest	Losi Micro-Rock Crawler	19	02-15-2012 12:14 AM
pics from axial comp prt 2	dbledeuce	New Mexico	0	04-18-2010 10:02 AM

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Sponsored Links

RCCrawler Forums

Thread: UC FAB PRT Question