Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

theres 2 "thumbsup"

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

I'm slowly hacking away at little sensored outrunners. Just got sensor board with a design design for standard sensor plugs. Waiting on rotors from China and stator from Japan. "thumbsup" pics later

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

Took a pic before I left the shop and I guess it didn't save, arg!

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

I swear I've been working on motors! These tiny shits are difficult in ways unexpected. Six sensor boards made, which gives one left for me and one for somebody else...

I have 90 degree and straight headers for the sensor plugs. Preference for Brian? I went ahead and added filter caps and pull up resistors for super snappy signals.

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

Those look Good John,

Vertical header would be the way to go for me.

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

The small holes route phase wires out and under, big holes let them pass back outside the can radius in the same direction as the sensor harness. Also strain relief.

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

Still like about 1000kv?

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

1000 kv will definitely do the trick. Though if you can go lower we should chat.

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

This thing is amazing! Ingenuity at its pinnacle! Count me in if it ever makes it to production.
I wish I had the resources to make some of my half-crazy inspirations come to reality.

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

Thanks man, It was a fun challenge to push the envelope and make something different. Might try some urethane casting on some of the parts and see if It is strong enough. Doing everything from carbon and billet Aluminum would drive the cost higher than most would want to spend, Add 2 servos, 4 speedos, 4 motors, and a 7 channel receiver and it adds up quick. :shock:

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

Bump :mrgreen:

These boards are so pretty did they get put on any motors?

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

I have a stack of sensor boards, and finished one endbell before petering out! I have another factory helping with endbells right now, along with some prewound stators being made by scorpion. I just can't afford the 40 hours it would take to build your set from scratch, so help from other factories was put into motion to pick up my slack.

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

So are you bringing the M.O.W. rig to jamestown?

Sent from my ALCATEL ONE TOUCH Fierce using Tapatalk

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

Negative, It is in a state of upgrade but non driveable right now.

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

Any updates on this project?

Sent from my ALCATEL ONE TOUCH Fierce using Tapatalk

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

What he said "thumbsup".

Re: BC-Brian's Real life Unlimited MOW with a dash of something crazy
 

Bump on MOW Brian.