Pro bumpers? Could someone measure the inside section of the rear bumper for me as in if I chopped off the outside parts and left that main section what would be left? Would like to see if it will work for me. I included a pic of said section. https://i.ibb.co/yg7VvDQ/Screenshot-...07-26-57-1.png |
Re: Pro bumpers? 1 Attachment(s) This should be within a few MM. Not exactly sure where you plan to cut it. "thumbsup" 107mm / 4.21" |
Re: Pro bumpers? On both sides of that center section and the connecting tube that run outward to the out sides. My idea was to make a stubby rear bumper to finish out a rear cage. I think it would look like a lot of truggy/ tube bed rigs also I like the idea of the recessed hitch which is also seen in 1:1 rigs with rear cage/ tube beds. It was an idea I had pop in my head this morning. |
Re: Pro bumpers? |
Re: Pro bumpers? I found that with this rear bumper trimmed and the hitch mount angled off that I had a 75 degree departure angle on my rebodied Element Enduro Kit chassis. Trimmed down to a very useful shape that I should be able to fit to other vehicles. Excellent bumper! |
All times are GMT -6. The time now is 11:18 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com