| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
07-31-2020, 08:27 AM
| #1 |
| Newbie Join Date: Dec 2018 Location: East Berlin
Posts: 4
|  Grub Screws for driveshaft at transmission
Having trouble finding a schematic of driveshaft where it attaches to the transmission for both front and rear, but I'd like to replace at least two of the four grub screws that have rounded out a bit. I believe I've found them, but just want to confirm they are 3 x 5mm, Vaterra part # VTR235322. Thanks in advance for the help.
|
|  |
| Sponsored Links | |
| | |
|
08-23-2020, 06:32 AM
| #2 |
| I wanna be Dave Join Date: Aug 2004 Location: central VT
Posts: 2,300
| Re: Grub Screws for driveshaft at transmission
That's the size. Just note that vaterra had a weird habit of using a 1/16" driver for some of there grub screws, which is odd to use a standard driver for a metric screw. This is notable because 1/16" is a hair larger than the 1.5mm you'd expect, which makes it easy to round out with the incorrect driver.
|
|
| |
|
Grub Screws for driveshaft at transmission - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What are these grub screws for? | Gazzalene | Axial Yeti | 3 | 12-11-2019 11:50 PM |
| Mip cvs grub screws (°_°) | CrawlinMike | Tools, and Procedures | 6 | 09-09-2014 07:50 AM |
| X-Factor axle shaft grub screws | amstel78 | XTM Crawler | 3 | 09-27-2008 03:54 PM |
| Grub Screws | BrockGrimes | Tamiya TLT Crawlers | 0 | 03-10-2007 03:27 PM |
| |
Linear Mode
