RCCrawler Forums - Driveshaft lenght

RCCrawler Forums (http://www.rccrawler.com/forum/)

- Vaterra Ascender (http://www.rccrawler.com/forum/vaterra-ascender/)

- - Driveshaft lenght (http://www.rccrawler.com/forum/vaterra-ascender/610425-driveshaft-lenght.html)

Damond

07-21-2019 11:33 PM

Driveshaft lenght

What are the driveshaft lengths on the K5 ?

Natedog

07-22-2019 10:59 AM

Re: Driveshaft lenght

Quote:

Originally Posted by Damond (Post 5951646)

What are the driveshaft lengths on the K5 ?

I don't know the exact lengths off-hand (can measure later if you want), but the rear should use two longest pieces (male/female) and front the two next longest pieces from the kit. "thumbsup"

Damond

07-22-2019 01:18 PM

Re: Driveshaft lenght

Thank you much appreciated

Sent from my iPhone using Tapatalk

Natedog

07-24-2019 10:01 AM

Re: Driveshaft lenght

You're welcome, compressed lengths: front measured about 95mm and rear about 105mm.

Buy the Vanquish Products driveshaft adapters for Ascenders and run whatever smaller diameter and more scale looking shafts you want. I bought them and mocked up on my WB K10 last night! :)
ASCENDER DRIVESHAFT ADAPTER
SKU: VPS08200
https://www.vanquishproducts.com/asc...shaft-adapter/
SCX10ii or TRX-4 shafts will work, might need to trim or swap the different lenght parts around.

All times are GMT -6. The time now is 01:27 AM.