VTH rear MIP X-Duty CVD $10 Close out |
Re: VTH rear MIP X-Duty CVD $10 Close out Thanks, bought 2 |
Re: VTH rear MIP X-Duty CVD $10 Close out Woah! super thanks. Also bought 2! |
Re: VTH rear MIP X-Duty CVD $10 Close out Thanks for the heads up. Bought 3 for basically the price of one. |
Re: VTH rear MIP X-Duty CVD $10 Close out bought me 3 also. can always use these on other rigs (since I already have one on my twin hammers) |
Re: VTH rear MIP X-Duty CVD $10 Close out Thanks ! +1 |
Re: VTH rear MIP X-Duty CVD $10 Close out Anybody know what these will fit without issue. I'd grab one for my my bomber but I think it'll be too short. How about an scx10? |
Re: VTH rear MIP X-Duty CVD $10 Close out Quote:
Diameter is same for scx, but I believe these will be a little short for scx regular wheelbase. Sent from my iPhone using Tapatalk |
Re: VTH rear MIP X-Duty CVD $10 Close out Yes thanks for the heads up, especially since I'm new to rc and started with the twin hammers. I would have missed out on an important improvement. Also ordered two, just in case. |
Re: VTH rear MIP X-Duty CVD $10 Close out can anyone confirm if this will work when you have the extended length rear arms on the twin hammer? |
Re: VTH rear MIP X-Duty CVD $10 Close out I have yeti trailing arms on my Twin. I used the male section of a Yeti MIP and joined it with the MIP I had on the twin before I stretched it. The reason I mixed them was one Shaft uses two set screws were the other has one threaded pin that goes through the outdrive. |
Re: VTH rear MIP X-Duty CVD $10 Close out I believe they are sold out now Sent from my LG-H900 using Tapatalk |
Re: VTH rear MIP X-Duty CVD $10 Close out Quote:
|
Re: VTH rear MIP X-Duty CVD $10 Close out Glad I got my order of 3 sets in. Showed up yesterday. |
Re: VTH rear MIP X-Duty CVD $10 Close out Quote:
|
Re: VTH rear MIP X-Duty CVD $10 Close out How strong is the stock vaterra one? Likely to break? |
Re: VTH rear MIP X-Duty CVD $10 Close out I've beat on mine for a year now and it hasn't broken yet. But you never know. Nice to have something very strong and keep the stock for a spare. Sent from my LG-H900 using Tapatalk |
Re: VTH rear MIP X-Duty CVD $10 Close out OK everyone I need your help. I can not remove the old CVD because the person that sold it to me (never buy on ebay again) broke the tip of his driver off in the grub screw. any ideas? |
Re: VTH rear MIP X-Duty CVD $10 Close out Quote:
I think you are looking at some drilling. Get a bit about the size of the grub screw and give it a shot. If you have a drill press it would help. |
Re: VTH rear MIP X-Duty CVD $10 Close out No drill press. just hand drill. Any recommendation on drill bit type |
All times are GMT -6. The time now is 04:35 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com