Bling From Behind? (Alloy Diff Cover?) I want to add an alloy diff cover to the back of my TH. Although I cannot find an alloy cover specifically for the TH, I believe that I read a while back that the cover from another rig will fit. I just don't know what vehicle that is. Maybe an Axial Wraith? If you know that answer, please enlighten me! Thanks! |
Re: Bling From Behind? (Alloy Diff Cover?) If you just want shiney chinesium, I believe either Integy or RC4WD (both?) made complete aluminum housings. |
Re: Bling From Behind? (Alloy Diff Cover?) 1 Attachment(s) Quote:
I really do hope that someone on this forum has done this and can tell me what diff cover from another car will fit the TH. See attachment below for the part I'm asking about: Attachment 387072 |
Re: Bling From Behind? (Alloy Diff Cover?) 1 Attachment(s) This might be a possibility. The parts explosion is from an old Axial Ridgecrest with an AR60 Diff. Maybe I'll order a cheap plastic one to see if it fits. If so, then I can buy a better one. I'm still open to suggestions, though. I'd be surprised if nobody has done this to their TH. Hmm, after staring at these two parts for a bit, I think the AR60 cover is too tall. Back to the RC Parts Explosion Board! Attachment 387075 |
Re: Bling From Behind? (Alloy Diff Cover?) Your dreaming if you think any other RC's diff cover will fit a Twin Hammer. The twin hammer axle is very unique in several ways, your not just going to adapt another cover to fit. Plus there is nothing wrong with the stock rear axle or its cover. |
Re: Bling From Behind? (Alloy Diff Cover?) Quote:
|
All times are GMT -6. The time now is 09:14 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com