|
| LinkBack | Thread Tools | Display Modes |
08-28-2009, 04:27 PM | #1 |
Quarry Creeper Join Date: Sep 2007 Location: NE Ohio
Posts: 267
| Remote Diff Lock Servo??
Would the Remote Diff Lock servo have enough torque to directly connect to the Lock Switch if I mount it to the front axle. I know I saw someone on here do something like that already but with a different servo. Chris |
Sponsored Links | |
08-28-2009, 05:36 PM | #2 |
Quarry Creeper Join Date: Dec 2008 Location: Post Falls, ID
Posts: 337
|
i guess that would depend on how long your servo arm is. if you keep it short as possible, it should work fine. you dont have the added friction of the cable to combat if you go that route, but the trade off is having a more fragile part out where it could get hurt. |
08-28-2009, 09:37 PM | #3 |
Quarry Creeper Join Date: Sep 2007 Location: NE Ohio
Posts: 267
|
I'll have to look at the servo again, but it looked like it had a short arm on it. I was planning on added a short link from arm to the diff lock slide, but will have to double check tomorrow. Chris |
Thread Tools | |
Display Modes | |
| |