what kind of servos are you guys useing
 

i was just seeing what everyone is useing im kinda a noob at crawling but i had a axial rtc but im getting back into crawling and the axial is was all ready to go and the venom is not so i got a hitec hs 7950th if anyone has it or can anyone tell me if it will work good in a crawler and i know i need a bec for this one thanks

I use a Hitec 475BB in mine. Of course im just a rookie also.

I have run both of these and prefer the first one.
http://www.hobbycity.com/hobbycity/s...idProduct=6222
http://www.hobbycity.com/hobbycity/s...idProduct=8739

I have rooted far more expensive servos and have yet to kill either of these.
My buddy has a CK as is a lot rougher than me, has not yet killed his Towerpro either.

There are many options open to you as far as servos go.
Just make sure you get a strong metal geared one. 10 kg/cm is my minimum.

I was not so lucky with Tower pro. Killed two in one week. I now run an Airtronics 94780. 423in/oz at 6v.

I use the same airtronics and it can't be beat.

hitec 5645

Cirrus CS704MG
195oz, .15 transit at 6v
33$ Shipped :mrgreen:

I'm running a towerpro MG995 at 7 volts, works fine for me

I run the Jr Z9100T. It does the job well"thumbsup"

My axial has the 9100 JR but f the creeper is just being built for people to come out and crawl with me, so it is gonna make use of some 995's i got sitting around. i figure they wont last, but I got a few to use before spending real money on a new one.

.
 

i just ordered 2 MG995 on ebay 18.95 all together.

I run a 7950TH...aside from it being noisy (lots of feedback for some reason) it is very good. I know five other rigs who I have driven with running the 7950TH and its very strong. I run mine at 6V (408oz)currently but at 7.4 you get tons of power (486oz.) so def worth it plus Hitec warranty is the best.

do you have any weight on your truck if so how much

I'm running the 7955-TG and for $85 it's a beast.
Can easily push & move rocks and can easily get some control when up against rock or wall.

You could also run the 7954-SH (333/403) which runs about $80-$85 as well

I have a decent amount of weight. My rig weighs in at 6lbs 3oz overall. Im running Vanquish DH Procomp wheels with 4oz wrapped on rim and then various Vanquish weights in the wheels. I believe the front wheels with tires and foams mounted currently weigh in at 14.5oz each. i have been playing with the weight a lot lately. The servo its self can move rocks off the course :) One guy I know, front wheels weigh in at over 16oz each and he runs same servo...no issues. "thumbsup"

well so i got a good sevro then cool so my next ? is i am going to use the stock wheels and im going with chisel tires so how should i fix/hold weight to my truck

Im using a JR z9100S. It works great but Id rather have the z9100T.