| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
03-22-2013, 02:40 AM
| #1 |
| Pebble Pounder Join Date: Nov 2012 Location: Australia
Posts: 118
|  will the venom cvds fit into an axial type steering knuckle?
hey guys i've searched you forum and come up with some confilcting answers. i have a crawler that uses axial type knuckles and im looking to do a cvd mod and i have read the venom cvds have a 5mm thick axle attached to the cvd joint, which is what i need as i am going to have to shorten 2 long shafts and drill the to insert a drive pin as i require a bogbone at my gearbox my Q is will the stub fit an axial type knuckle with or without modifycation? cheers guys david. |
|  |
| Sponsored Links | |
| | |
|
will the venom cvds fit into an axial type steering knuckle? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Axial High Clearance steering knuckle | volvoc304 | EnRoute Berg | 10 | 04-19-2010 04:04 PM |
| MIP CVDs or Axial CVDs? | CarLo | Axial AX-10 Scorpion | 27 | 12-23-2009 10:49 PM |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
