Newbie mistake Ok, so i did it the newbie mistake:sad:. I got the Maxstone 8 which was bad move on my part.Two days out the box the rear gears stripped out. I now see that parts are hard to find. So now I am wanting new axles. In looking around and reading alot of forums, Bergs or Bully seem to be the best options. Is there anny other axles that i should look at? |
Re: Newbie mistake I'd do bully axles over bergs. Bergs are just as hard to find parts for as exceed axles. Ask me how I know. Go bullies and don't look back, that's what I'll do when I get the money. |
Re: Newbie mistake BERG. berg gears and parts can be had from vendors on this forum. berg gears fit into the exeed MAD crawler but dont know about the 1/8.. they may have the same gear cases. worth looking into. just go buy a used ax-10 for less than some axles and you will be happy Im sure."thumbsup" good luck and sorry about the exeed crap |
Re: Newbie mistake I'm pretty sure the maxstone gears interchange with ax10 stuff but I'm not positive. Post up a picture of the gears. The mad torque gears interchange with berg gears, thats what i did. |
Re: Newbie mistake max stone and ax10 have nothing in common. |
Re: Newbie mistake I wonder if you could put berg v2 gears in a max stone... |
All times are GMT -6. The time now is 05:28 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com