Official WiRCRC Chit Chat

[corporatelemon]

I figured why not

[crawlinisfun]

anyone else have any 2.2 scale rigs or am I the only one in the group still lol

[corporatelemon]

My taco or super duty go 2.2 once in a while

[crawlinisfun]

Nice, some of the places here are good for 2.2 the 1.9 just can't reach over the ledges that have good lines to try, I know when super and traildawg came last time I think they had 2.2 rigs I blew a diff in my losi and barrowed a friends roller with my guts and sank it in a deep hole only could see one wheel

[corporatelemon]

Watching the weather and Im seeing 30's!!!

[crawlinisfun]

heat wave

[Super]

Originally Posted by crawlinisfun

anyone else have any 2.2 scale rigs or am I the only one in the group still lol

The only thing I run 2.2's on is my Pro-Line tuber bodied AX10 and of course my Bully.

[Super]

Originally Posted by corporatelemon

Watching the weather and Im seeing 30's!!!

Gonna take a long time to melt all of this snow and thaw us out.

[corporatelemon]

I know it sucks

[corporatelemon]

I have been searching here for a servo bec jumper plug thingy to run my savox off my cc bec but can't find it for the life of me

[corporatelemon]

Any help would be great

[Super]

Not sure what you mean???

[corporatelemon]

It's a little jumper harness that only powers the servo off the bec yet provides ground and signal from the receiver allowing the esc to power only the receiver and the bec only powers the servo

[Super]

I guess I always plug my stuff into the receiver, never used a jumper.

[corporatelemon]

Same here just want to see if the servo was stronger that way

[Super]

I think as long as you are not "browning" out your receiver I think you're alright.

[corporatelemon]

Ok that's what im trying to avoid but the receiver can take up to 7.4 volts I want to say ill have to read tonight and make shure and verify what the servo can take max!!

[crawlinisfun]

Most rc servos are only 9.6v max same with Rx, you can set the bec to the max voltage but its only going to put out 8.4v max for a 2s lipo and go down to 6.6v as the battery is used but with a 3s lipo your servo would see 9.6v continuous

[corporatelemon]

True

[crawlinisfun]

at least that's what the castle creations website says